 |
 |
|
|
 |
|
 |
|
|
|
|
|
 |
|
Coemar NAT 1.2K TM
Coemar NAT 2.5K TM
Coemar NAT 4K TM
And all smaller units*...
* Subject to further testing |
|
|
The NAT Lighting Enclosure was conceived with Coemar NAT TM luminaires in mind. It can be mounted in almost any position and provides complete environmental protection for the luminaire. The end of the sturdy fiberglass body is an acrylic globe, which provides 360° of pan and 260° of tilt freedom for the TM head. The globe is held securely in place with three latches around its perimeter, two of which are padlockable. For access to the luminaire itself, the lid of the enclosure can be easily removed by releasing the two latches on either side.
As with our other products, it is designed for long-term and permanent installations in exterior environments where minimum maintenance is required. But it can also be used in indoor environments where conditions may be detrimental to moving lights (dust, smoke, high humidity, contact with moving bodies or objects).
While the enclosure body provides basic protection for elements, the interior is climate controlled through the DEC (Digital Enclosure Control) System. This system is composed of a controller, cooling elements (in this case, 3 fans), and a heating element. By monitoring the enclosure environment, the DEC System can control temperature and humidity inside the enclosure. By doing this, condensation can be eliminated and thermal stress can be significantly reduced.
In the end, this complete protection system will reduce maintenance, increase lamp life, extend fixture life, and save you money in your outdoor use of NAT TM luminaires. |
|
|
|
|
|
|
|
Non-corrosive fiberglass composite body
Stainless steel and aluminum structure and hardware
24" optically clear acrylic projection globe |
|
|
External - Two lateral 30" P4000 Perma-Green 1-5/8" UNISTRUT™
Internal - Custom yoke bracket system |
|
|
 |
|
|
Automotive enamel
Three standard colors available (light beige, white, gray) |
|
|
Digital Enclosure Control (DEC) System
Microprocessor controlled system with LED display showing status
Enclosure is rated for an external ambient of 95°F (35°C) with luminaire on and 120°F (49°C) with luminaire off. |
|
|
Dual-speed forced air cooling provided by two 230CFM fans and one 300CFM fan |
|
|
Proportionately controlled 750W heater coil on intake |
|
|
Washable open-cell foam filter on intake |
|
|
External DMX control cable fed through exterior 1/2" NPT hub (cable not included) |
|
Two draw latches with positive catch (on both lid & globe)
Two draw latches with padlock holes (on both lid & globe)
Stainless steel eye bolt on exterior for safety on security |
|
|
Over-temperature/failsafe relay can cut off power to luminaire
Safety cables attaching lid, globe, & intake cover |
|
|
| Connections made in condolet box |
|
|
Hard-wired on site
200-240VAC 50/60Hz 7A
Must receive power at all times for protection |
|
|
Feed-through NAT receptacle provided
Ballast requires independent weather protection (enclosure available, not included) |
|
|
|
ETL & cETL listed to U.L. Standard 508
NEMA Type 3R (similar to IP rating of 54) |
|
|
Empty enclosure weight is approximately 62 lbs. (28kg)
Shipping (crate) - 225 lbs. (102kg) - 81" x 30" x 36" |
|
|
 |
|
|
|
|
|
|
|
 |
|
 |
|
|
|
|
